Affinity Designer Flood Fill Tool "Antialias" problem?

[nasu wong]

And Margins in Document setup not working too! I can't add "Include Margins" I'm on Window10. Thanks. 

[Chris B]

Hey nasu wong,

You have switched to the Pixel Persona and the Fill Tool is going to fill whole pixels. If you enable the Pixel view mode on the toolbar at the top you might get a clearer idea of what is going on. The fill will depend on whether the pixel is under or over 50% grey.

Regarding the margins, you will also need to enable the margin view by going to View > Show margins.

I hope this helps.

[nasu wong]

@Chris B Thank you. I switch between Designer and Pixel Persona. When working in Designer and then switch back to Pixel Persona, the view setting I choose for pixel view reverts back to Vector view. Dose that mean I have to click and select it every time in order to see the antialiasing, right? I remember that the previous version didn't display this way. Or maybe I'm remembering it wrong. Thanks again.

[Chris B]

It does seem to reset in V2 so I checked V1 and it also does the same. There was maybe a mid-cycle version where it did not do this. I can look into it and maybe even log a request to retain whatever view mode you want when switching personas.