luispedrofonseca Posted October 19, 2014 Share Posted October 19, 2014 Hi, I'm trying to export @3x slices but for some reason it's not working. I get a warning sign saying the resolution is too low for @2x export (which works), but not @3x. Any idea what's going on? Cheers, Personal website - http://www.luispedrofonseca.com Follow me on Twitter - https://twitter.com/lpfonseca Link to comment Share on other sites More sharing options...
Staff TonyB Posted October 19, 2014 Staff Share Posted October 19, 2014 Could you post an example afdesign file that fails to output @3x please. Link to comment Share on other sites More sharing options...
luispedrofonseca Posted October 19, 2014 Author Share Posted October 19, 2014 Sure, here you go. test.afdesign Personal website - http://www.luispedrofonseca.com Follow me on Twitter - https://twitter.com/lpfonseca Link to comment Share on other sites More sharing options...
Staff Andy Somerfield Posted October 19, 2014 Staff Share Posted October 19, 2014 EDIT: But it doesn't write 3x - ok - will fix.. :) Interesting, I get no warnings here, using your file. I'll go over the code again to make sure it's working right, though. Thanks, AndyS Link to comment Share on other sites More sharing options...
luispedrofonseca Posted October 19, 2014 Author Share Posted October 19, 2014 Hmmm... You probably don't get any warnings because I removed the other layers that contained pixel objects. I don't get it either on the file I sent. But it still doesn't export the @3x. Personal website - http://www.luispedrofonseca.com Follow me on Twitter - https://twitter.com/lpfonseca Link to comment Share on other sites More sharing options...
dangerman2000 Posted October 29, 2014 Share Posted October 29, 2014 I got this error as well. I had used the same name twice for a slice and it gave the error. It was a bit misleading. It was hard to track down because there were a plethora of icons on the page that I was exporting (scrolling on the small 'Slices' panel). Expected: There should be validation when naming the slice to ensure it's a unique name. I have not checked to see if it checks for valid names (avoid invalid characters : ' " etc.) , but if not it should do that too! :) Link to comment Share on other sites More sharing options...
Recommended Posts