iPad Designer: Can’t Round a point using Corner Tool.

[VectorCat]

Screencapture shows the two corner points I’m working with. The right one will round using the Corner tool; the left won’t. It appears to be just one point. Object is a curve. Any clue what the issue is?

Thank you

 

CantRoundBottom2Corners.afdesign

[Alfred]

I think it may be caused by the off-curve handle of the other node on that side being coincident with the bottom left-hand node.

[DWright]

As @Alfredmentioned if you drag the bottom curve handle away from the bottom node you can then apply the rounded corner to this node.

[VectorCat]

You are both quite right…thank you!