Failed to save document message

[Gear maker]

I'm not sure what happened, but there is a message saying I should report this to the development team.  So here it is.

I had a couple circles, saved them as a starting point for my drawing.  I then grabbed an svg file of a spiral created using Inkscape.  This file was dragged and dropped into the existing drawing.  I grouped them, then hit save and received a failed to save message.  I have used spirals created in Inkscape a couple times in the past without a problem.

AD Beta 2.2.0, 2018 Mac running Ventura.

Inkscape file:  Spiral 14.svg

[Hangman]

Hi @Gear maker,

The file is working fine here... if you repeat the exercise in a new document do you see the same issue... where are you saving the file, to your local HD or an external HD?

[Gear maker]

5 hours ago, Hangman said:

Hi @Gear maker,

The file is working fine here... if you repeat the exercise in a new document do you see the same issue... where are you saving the file, to your local HD or an external HD?

I keep all data on an external HD.  I didn't try it a second time.  I restarted it again, but used a different spiral file.  The only reason I turned this in is that is what the message in AD asked me to do.  Personally I was curious, but not too worried about the problem.  But thanks for checking it out Hangman.