Change default stroke and fill

[AaplMike]

Hello.

Every time I launch, the stroke and fill default to no stroke some light gray fill. I NEVER use these values and always have to end up changing them to my preferred values.

How to I CHANGE the default values for strokes and fills so I don't have to constantly change them?

Thanks.

[DWright]

Is it possible for you to post a screen shot showing this issue.

[lepr]

15 hours ago, AaplMike said:

Hello.

Every time I launch, the stroke and fill default to no stroke some light gray fill. I NEVER use these values and always have to end up changing them to my preferred values.

How to I CHANGE the default values for strokes and fills so I don't have to constantly change them?

Thanks.

 

The default fill and stroke can be changed from the factory values (light grey fill and no stroke) to your preferred values:

1. Select an object that has the preferred fill and stroke
2. Edit > Defaults > Synchronise From Selection (also, a button for this command is on main toolbar)
3. Edit > Defaults > Save

 

[AaplMike]

Well...that was easy. Awesome!

[Cenda]

Every time I draw a line, I get a no fill and a stroke. Even though I tried the procedure above (Sync from selection) it still doesn't work. Any idea what the problem might be?

[Cenda]

47 minutes ago, Cenda said:

Every time I draw a line, I get a no fill and a stroke. Even though I tried the procedure above (Sync from selection) it still doesn't work. Any idea what the problem might be?

I just updated to 2.6 and it works!