Transform panel, "y" reading

[MickRose]

Beta 283. I know it has been mentioned before about the y reading in the Transform panel being wrong but there seems to be a sort of pattern here. The rectangle was drawn so it stretched as far as the top of the following page. Page 1 is correct, page 2 reading is too low by 30mm + page height (130mm), page 3 is too low by twice that amount (260mm), page 4 is too low by three times that amount (390mm).

[Jon P]

Hi Mick,

We are aware of this and should hopefully have a fix for it in a future beta.

Thanks!

[MickRose]

Thank you.