Affinity Rat Posted September 30, 2022 Share Posted September 30, 2022 I’m trying to make a selection based on the intersection of 2 layers or curves. By grouping 2 layers I can make an additive selection but so far been unable to do other boolean operations. Any suggestions? Quote Link to comment Share on other sites More sharing options...
Staff Dan C Posted September 30, 2022 Staff Share Posted September 30, 2022 Hi @Affinity Rat, Personally, I would select both objects then use the Divide command in order to create a separate layer for the area of both objects that intersects. Then, with this new layer selected, I ran the 'Selection from layer' Macro that Mr Mudditt kindly provided here - Which results in a pixel selection area where the 2 objects intersected, as per the below screen recording: RPReplay_Final1664548212.MP4 I hope this helps! Affinity Rat and Paul Mudditt 1 1 Quote Please note - I am currently out of the office for a short while whilst recovering from surgery (nothing serious!), therefore will not be available on the Forums during this time. Should you require a response from the team in a thread I have previously replied in - please Create a New Thread and our team will be sure to reply as soon as possible. Many thanks! Link to comment Share on other sites More sharing options...
Affinity Rat Posted October 3, 2022 Author Share Posted October 3, 2022 Thank you very much, I’ll give it a try. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.