visualrevolt Posted October 11, 2020 Share Posted October 11, 2020 Hello there, I have a problem with rounding corners inside the shape. Here are steps to recreate this bug. -Draw the hexagon or any shape. -Select Contour tool -Select contour fill - (Open fill) - Increase the gap inside to desirable size. then bake apperance. After this, select corner tool from the toolbar and try to round all corners. In my case I can do this on 1, 2 corners depends what shape I currently use. The tool doesnt respond at all . Best Regards PJ Link to comment Share on other sites More sharing options...
lepr Posted October 12, 2020 Share Posted October 12, 2020 Welcome to the Affinity forums The problem is the paths produced by the current Contour Tool; they can have coincident nodes and/or smooth nodes where there should be sharp nodes. These paths tend to render OK, but they can be problematic for subsequent operations after being baked to user-accessible objects, as you've discovered. Corner Tool does not operate on smooth nodes, and it cannot create a corner at coincident nodes because there is no distance between these nodes. Hopefully, Contour Tool will be improved very soon. Sean P 1 Link to comment Share on other sites More sharing options...
Staff Sean P Posted October 13, 2020 Staff Share Posted October 13, 2020 Hi VisualRevolt, Thanks for letting us know. I've passed this over to development to take a look into and see if they can make some improvements to it! Link to comment Share on other sites More sharing options...
Recommended Posts