Ziflin Posted February 11, 2019 Posted February 11, 2019 The Transform Tool does not seem to take into account ruler offset changes when displaying X & Y values. Create a new document (say 100x100 pixels). Enable the Ruler: View/Show Rulers Offset the Y-axis such that 0 is now in the center. (Drag from the top-right corner of the rules down 50 units). Select the Pen tool and click anywhere along the Y=0 axis. Note that the new node point still will show Y=50 in the Transform Tool. This seems like a bug and make it very confusing to use an offset axis without the transform tool showing the proper location for nodes. transitdiagrams 1
Staff Sean P Posted February 12, 2019 Staff Posted February 12, 2019 Hi Ziflin, I've reproduced this and will get it passed on to development. Thanks for letting us know. transitdiagrams and Ziflin 1 1
Recommended Posts