Gear maker Posted December 20, 2018 Share Posted December 20, 2018 The beta crashed moving an adjustment layer from one layer to another. Just a couple minutes after reopening the recovery file. Crash 3rd on 12-20-18.txt I'm early in a new project, I think I'm going to switch to using the released version. iMac (27-inch, Late 2009) with macOS Sierra Link to comment Share on other sites More sharing options...
JFisher Posted December 21, 2018 Share Posted December 21, 2018 Hi Gear maker Thanks for your post, I have been able to replicate this issue. I'll get this logged! Link to comment Share on other sites More sharing options...
Gear maker Posted December 21, 2018 Author Share Posted December 21, 2018 I was thinking last night that all these crashes happened after I had pasted a few layers from an old drawing (mid 2015) into this document. I deleted all these layers, then opened a copy of the old document in 1.7, then copied the converted layers into my new drawing. So far after a half hour of adjustments no crashes. Could this have caused the crashes? iMac (27-inch, Late 2009) with macOS Sierra Link to comment Share on other sites More sharing options...
Gear maker Posted December 21, 2018 Author Share Posted December 21, 2018 Mr. Fisher, I spoke too soon, I had done several changes with no problems but then I tried using the corner tool, selected 4 corners, corner type rounded, then as soon as I clicked on the Specify corner radius pull down arrow it crashed. The second time I tired it the result was exactly the same. The third time it worked as it should. I'm just hoping this will give you more info that will make it easier to solve the crash. Thanks. Mike Crash 12-21-18.txt iMac (27-inch, Late 2009) with macOS Sierra Link to comment Share on other sites More sharing options...
Recommended Posts