jfw222 Posted August 26, 2018 Share Posted August 26, 2018 In PS there is a function called the Fill Mode. It is different fro Opacity. What is comparable in AF? Quote Link to comment Share on other sites More sharing options...
Staff Gabe Posted August 28, 2018 Staff Share Posted August 28, 2018 Hi @jfw222, Welcome to the forums. You can use Source Layer Ranges from Blend Options for this. Thanks, Gabe. Quote Link to comment Share on other sites More sharing options...
feinwasser Posted August 28, 2018 Share Posted August 28, 2018 Could you elaborate on this? Like, is a fill level of 50% in PS equivalent to pulling the left or the right node or both down to 50% in AP? Thanks in advance! Quote Link to comment Share on other sites More sharing options...
Staff Gabe Posted August 28, 2018 Staff Share Posted August 28, 2018 Sure. My bad. Under "Source layer ranges" you have 2 handles. You only need the left handle to replicate "fill". Drag it down slightly to make the "In" and "out" active. Set "In" to 0, and the "out" would be the "Fill" value. feinwasser 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.