dodge and burn with inverted layer

[edward g]

in AP v2.0 i could use e.g. levels to change opacity levels to an area, then invert layer to hide changes. then use paint brush white to reveal part of the inverted layer i wish to be lighter/darker. however this seems to nolonger work. comments please

thanks Edward G

[carl123]

Check the Blend Mode of the Brush (in the context toolbar) is not set to Darken, it should be on Normal.

There's been a lot of that lately

If not that please supply a full screen screenshot at the point it does not work

[edward g]

thank you carl123 that seems to have sorted the problem, not sure how the brush changed  to darken but,  happy and grateful for you advice.

 

edward g