What is this?

[Branlid]

I want to chop up a persons face. I used the smart pen to make a selection, then cut and paste in to new pixel layer. But when i move the ”pieces” around, there are som ghost lines left from where the selection was made. What is that?

[DM1]

Check your Hackad.png layer. It’s probably pixels left when your did the initial cutting out of the head. If they show there, just use the eraser to remove them.🙂

[Branlid]

I actually found that when i used the smart pen tool to make the selections, it sometimes changed from o,o pixels to o,2 pixels witch then created these lines.