FraGar Posted August 11, 2023 Posted August 11, 2023 Im having an issue that the design I ctrl alt copy, "warps/changes" when I try to make a pattern. It moves to the left as I ctrl j to copy it down, after I placed it. Am I doing something wrong or is it a bug? Quote
GarryP Posted August 11, 2023 Posted August 11, 2023 It doesn’t look like your diamond shapes were properly aligned before you started to duplicate them. It looks like there is a small ‘offset’ at the corners – see attached image where I have approximated where the edges of the diamonds seem to be (after a Levels Adjustment has been applied). Quote
FraGar Posted August 11, 2023 Author Posted August 11, 2023 Ok, Il se if it is alignment and test it over again. Thanks👍 Quote
GarryP Posted August 12, 2023 Posted August 12, 2023 Also check that your diamond shapes are ‘true diamonds’ and that the angles are correct; a ‘slightly off’ diamond – maybe not visually apparent – will also give you a problem with alignment. Quote
FraGar Posted August 12, 2023 Author Posted August 12, 2023 22 hours ago, GarryP said: It doesn’t look like your diamond shapes were properly aligned before you started to duplicate them. It looks like there is a small ‘offset’ at the corners – see attached image where I have approximated where the edges of the diamonds seem to be (after a Levels Adjustment has been applied). Jepp, it was like you thought. I messed up. So when I realigned it it was perfect. Thanks GarryP 1 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.