Transform Panel fails to display

[Dalton Downey]

The Transform Panel fails to display when selected. This is a new issue that seems to occur after I paste an object into a document.

[MikeTO]

Hi @Dalton Downey and welcome to the forums. When a panel fails to display it typically is displayed but it's 'off screen'. Sometimes if you use a two-monitor setup and leave a panel open on the second screen, or use a large monitor and leave a panel open at the far end of the screen, and then use a small screen such as a laptop the panel will be invisible since it's open somewhere you can't see it. Resetting your studios will let you retrieve the panel but it's somewhat easier to reconnect to the larger screen or second monitor and drag it back.

If you've always used the same screen and are having this issue could you please describe your setup and where you normally have the panel shown?

Good luck

[NotMyFault]

Normally it helps to use the „Window“ menu and cycle the visibility of transform panel.