carca Posted February 27, 2020 Share Posted February 27, 2020 When I horizontally mirror a a photo (a Quantas plane) with Geometrie/hor mirror) I get a perfectly mirrored image... Unfortunately the text (the Quantas logo in this case) is equally "mirrored" and not to be read... How can I settle this? Carca Quote Link to comment Share on other sites More sharing options...
Staff Dan C Posted February 27, 2020 Staff Share Posted February 27, 2020 Hi carca You'll need to manually select this area, cut and paste it to a new layer, then flip this layer and rotate it to fit the area. I found after this the original image required come 'inpainting' to remove the missing pixels. You can find this in the below screen recording - 2020-02-27 14-51-04.mp4 I hope this helps! Chip J. 1 Quote Please note - I am currently out of the office for a short while whilst recovering from surgery (nothing serious!), therefore will not be available on the Forums during this time. Should you require a response from the team in a thread I have previously replied in - please Create a New Thread and our team will be sure to reply as soon as possible. Many thanks! Link to comment Share on other sites More sharing options...
carca Posted February 27, 2020 Author Share Posted February 27, 2020 Thanks for thre super quick reply and the instructions... I check it this evening and report if successfull... Carca Quote Link to comment Share on other sites More sharing options...
carca Posted February 27, 2020 Author Share Posted February 27, 2020 Ok, I have now seen your video and understand roughly what you suggest... I am just stuck after the first manouver! I frame the text ok, and I suppose (I could not see it because you zoomed my small image) that I have to cut the selected text area. When I do this (with command cut), the selected area disapears, but I do not get the corresponding icon that apears in your video on the right, above the icon of the plane. Certainly because I used the "wrong" command. Can you further explain? Thanks in advance Carca Quote Link to comment Share on other sites More sharing options...
carca Posted February 27, 2020 Author Share Posted February 27, 2020 OK, now I have "made it"!! (See enclosed photo). Sure it looks more a glued label on the plane rather than the original logo they are so proud of but the initial question was on the princip and I have got it and I am going to do it better. Thanks so much for the help. carca Dan C 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.