Jump to content
Toby_y

Can't figure out how to fill text correctly when curves.

Recommended Posts

Hi, 

I'm trying to fill a capital 'O' without filling in the middle of it. As seen in the attached screenshots. 

I found a post with the same issue, there they were told to select the individual curve layers rather than the group, and then change the fill mode in the layers menu to "Alternative (Even-Odd)". 

However, I tried this and it didn't seem to work. 
Is there something I'm doing wrong or something else that might work? 

Cheers 

 

Screenshot 2019-09-04 at 12.41.13.png

Screenshot 2019-09-04 at 12.41.29.png

Screenshot 2019-09-04 at 12.41.53.png

Share this post


Link to post
Share on other sites

Select both of the curves that make your letter O then click the Xor boolean operations and this will remove the centre of the O and will allow you to fill the rest correctly.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...

Important Information

Please note the Annual Company Closure section in the Terms of Use. These are the Terms of Use you will be asked to agree to if you join the forum. | Privacy Policy | Guidelines | We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.