DNH Posted August 31, 2018 Share Posted August 31, 2018 I create a new document with one A4 page and place a design on it. Save the document and it prints OK. When I open that documet, the design is still on the one page i have created, bu as soon as i add another page or a master the design on the original page has disapeared and in not on any other page. Also all the layer information has gone. I chosen the option of no spreading. Disclabels.afpub Link to comment Share on other sites More sharing options...
DNH Posted August 31, 2018 Author Share Posted August 31, 2018 Found out an anwser, I should of doubled clicked on the page instead of single click. Single click would have been nicer. Link to comment Share on other sites More sharing options...
BalsallHeathen Posted August 31, 2018 Share Posted August 31, 2018 I tried your file without problem. Are you double clicking on page one to deselect the new page and return to one? Link to comment Share on other sites More sharing options...
BalsallHeathen Posted August 31, 2018 Share Posted August 31, 2018 Sorry, seems my answer and your own overlapped. I agree the single click would be my prerred option too. Link to comment Share on other sites More sharing options...
DNH Posted August 31, 2018 Author Share Posted August 31, 2018 thanks for your reply. I should experimented a bit more. One thing I need to know is can you revert to single pages after you have set up as spread format. Link to comment Share on other sites More sharing options...
BalsallHeathen Posted August 31, 2018 Share Posted August 31, 2018 I've been playing around with the document setup and I think what you need is: Click on Document Setup tab above Pages (or Click on File in menu bar then Select Document Setup (Ctrl+Shift+P)) In pop-up select Layout tab (about half way down box) You can toggle Facing Pages on and off here. Hope that is what you were looking for. Link to comment Share on other sites More sharing options...
DNH Posted August 31, 2018 Author Share Posted August 31, 2018 thanks for your help, just what i wanted. Link to comment Share on other sites More sharing options...
Recommended Posts