Jump to content

Recommended Posts

Posted

I create a new document with one A4 page and place a design on it. Save the document and it prints OK.

When I open that documet, the design is still on the one page i have created, bu as soon as i add another page or a master the design on the original page has disapeared and in not on any other page. Also all the layer information has gone.

I chosen the option of no spreading.

Disclabels.afpub

Posted

Found out an anwser, I should of doubled clicked on the page instead of single click. Single click would have been nicer.

Posted

thanks for your reply. I should experimented a bit more.

One thing I need to know is can you revert to single pages after you have set up as spread format.

Posted

I've been playing around with the document setup and I think what you need is:

Click on Document Setup tab above Pages (or Click on File in menu bar then Select Document Setup (Ctrl+Shift+P))

In pop-up select Layout tab (about half way down box)

You can toggle Facing Pages on and off here.

Hope that is what you were looking for.

×
×
  • Create New...

Important Information

Terms of Use | Privacy Policy | Guidelines | We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.