Point Transform Tool Not Showing All Nodes

[George-Frazee]

Not sure if I'm doing something wrong or not, but the point transform tool is not showing all available nodes after a certain point. It doesn't seem to be a specific number of points, or objects, and I can't pin down where the cutoff is.

Here is a curve with a lot of nodes selected with the node tool, and then with point transform:

 

And here is the bottom curve selected with both tools:

This one appears to show even fewer nodes. The result is the exact same whether or not the lines are separate or part of a merged curve

I've also attached the source file which has a few other "tons of nodes" examples which all behave the same.

 

Point Transform Limit.afdesign

[NathanC]

Hi @George-Frazee,

I've replicated and logged this with the developers using your file, thanks for your report!