How to use perspective to distort an image

[AGain]

Hello community, in my transition to AD2 I would like to distort an image like below but I haven't found a way in AD2.

I tried by using a perspective on a empty rectangle and then clipping the image in it but I was not able to replicate exactly the effect I achieved using my other sw using a 'free transform' tool. The result desired is in the picture attached.

I am sure this is possible in AD2 but I don't know how.

thx for any help

p.s. hope you don't tell me it's in affinity photo...

[GarryP]

Designer (V1 or V2) cannot warp (either mesh or perspective) pixel-based graphics, you will need Photo for that.

[Mr Sinister]

Yeah. I’ve found this to be the case, which is a bit of a pain for what I want to use it for.

Fortunately, I have Photo 2, so can - at least - try to create a workaround.

[v_kyr]

34 minutes ago, Mr Sinister said:

Yeah. I’ve found this to be the case, which is a bit of a pain for what I want to use it for.

Fortunately, I have Photo 2, so can - at least - try to create a workaround.

There's an old workaround for Designer here (which reuses the Perspective asset from APh, aka a pixel distortion,  in ADe then) ...

Though if you already have APh too, you can just switch between them in order to distort that bitmap/pixel image in/for ADe here.

[AGain]

Thanks for your kind replies...I supposed there was no easy way out in ADe2...I would also buy APh but I already have bought in the past other photo/pixel editing programs and this only feature does not justify the cost.

Great community here btw