igh033 Posted August 24, 2022 Posted August 24, 2022 Notice that flow rate. The brush flow rate is released excessively. Do you consider it a bug or is there something wrong with my settings? This issue suddenly appeared after I uploaded the OS. I did a clean install of this software. But the problem is still not resolved. I expect that the strength of the brush is weaker. Is there any solution other than using opacity? I am looking forward to your advice. Thanks 2022:08:24.mp4 Quote
Staff NathanC Posted August 24, 2022 Staff Posted August 24, 2022 Hi @igh033, I can't spot anything wrong with your settings which would cause the brush stoke to be excessively applied to the mask with your set flow rate. Does this issue continue to happen if you disable Hardware Acceleration under Preferences > Performance > Restart App. Additionally, is this file specific or does the same issue happen with regular brush strokes on a new document? If disabling H/A doesn't help could you provide me with your file so I can see if the issue can be replicated? I've provided a private dropbox link below. https://www.dropbox.com/request/ouzkbz6rN1JSrmVg70R1 Many Thanks Quote
igh033 Posted August 24, 2022 Author Posted August 24, 2022 Apparently the brush was broken. I reset them and reinstalled a new brush. Then everything was fine. Thank you very much for your support! NathanC 1 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.