Gaunilo Posted June 18, 2022 Share Posted June 18, 2022 I need to make a table where one column shows pictures i.e. a certain spare part with the information in the following columns. Somehow I seem to be unable to properly insert a picture. So far the only way seems to be to put the picture on the page outside the table, then cut it out (cmd-x), double click in the cell and insert it (cmd-v). If done, the picture will not align proberly because I don't have access position etc. in the table dialoge. And this can work with a picture or two but not with 50 pictures or 200. So – any other solutions? Thanks a lot! Herbert Quote Link to comment Share on other sites More sharing options...
GarryP Posted June 18, 2022 Share Posted June 18, 2022 Have you looked at the Data Merge functionality? I’ve not used it myself but I have heard good things. Quote Link to comment Share on other sites More sharing options...
Gaunilo Posted June 18, 2022 Author Share Posted June 18, 2022 Just now, GarryP said: Have you looked at the Data Merge functionality? I’ve not used it myself but I have heard good things. No, I have not. I will have a look at it now, though. Thanks! Quote Link to comment Share on other sites More sharing options...
GarryP Posted June 18, 2022 Share Posted June 18, 2022 You’re welcome. Apart from what’s in the Help, there are various forum threads regarding this so there should be quite a bit of information about different uses. Quote Link to comment Share on other sites More sharing options...
Gaunilo Posted June 18, 2022 Author Share Posted June 18, 2022 Just now, GarryP said: You’re welcome. Apart from what’s in the Help, there are various forum threads regarding this so there should be quite a bit of information about different uses. Strange… I did a search before posting but didn't find anything relevant. I'll look again. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.