arikw Posted October 22, 2018 Share Posted October 22, 2018 I'm using sony rx100m6. Mode raw+jpg when they open in affinity the raw looks so pale while the jpg is so vivid. Why? attached are 2 screenshots. arikw Quote Link to comment Share on other sites More sharing options...
Staff MEB Posted October 22, 2018 Staff Share Posted October 22, 2018 Hi arikw, Welcome to Affinity Forums The JPG was already processed by the camera according to manufacturer settings while a RAW file contains the data as captured by the sensor without any processing applied. When a RAW converter/developer software opens it, it usually applies some initial processing (noise reduction, tone curve etc) which you can usually revert if you want to (at least in part). This processing varies a little depending on the program you use to open the RAW, so the results may not only differ between them but also differ from the processed JPG the camera generated. Using the Develop Persona (RAW controls) you should be able to match or even get a better result than the one generated by the camera - it all depends on your workflow and how you want the processed file to be. Check this article in Affinity Spotlight to learn a bit more about RAW files. Quote A Guide to Learning Affinity Software Link to comment Share on other sites More sharing options...
arikw Posted October 22, 2018 Author Share Posted October 22, 2018 Thank u very much. It is very helpful! arikw Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.