Removal of CurveHandles

[IceExplosive]

Hello, I'm trying to move from Inkscape to Designer and can't figure out an easy way to straighten up curves.

Is there a way to remove curve handles for selected node?

In Inkscape there are options to either move the handler on top of node -> which removes it,
Or by clicking again on sharp node type to remove it from all selected nodes.

The same problem with Designer I've seen on some tutorial videos like:

https://youtu.be/1F-8tGXK9P8?t=1408

Where the author is creating a Mesh Warp for stairs, but have to adjust every single curve handle manualy and not even reaching actually straight lines.

Is this feature not supported in Designer?

 

[firstdefence]

You can convert nodes to sharp...

[IceExplosive]

Ou... I see the problem -> I was editing WarpNode which miss that feature -> regular do have it.

Edited February 12, 2023 by IceExplosive

[firstdefence]

Ah yes the warp node are very rudimentary, with very limited control or snapping unlike the standard curve nodes have. In fact the only thing you can change, other than a node position and angle, is whether you can independantly move the handles or have them as a seesaw effect.