A list of bugs / features #2

[Darner]

Second list of bullet points. See also first list:

Following Affinity info was part of considering to switch: "Affinity Designer is full of tools meticulously developed for achieving high productivity, while maintaining 100 percent accurate geometry.

After testing some geometric design and similar with angles and high accuracy I bumped into a couple of challenges. My apologies if some of these already exist, and it was just a setting issue, but tried different settings etc before writing. Would so much like to make good use of Affinity. I do understand there is a lot of request regarding features and bugs, hopefully this list includes these as well as some new ones. Thanks for doing what you are doing!

• Ability to Add in Geometry even though when grouped
• Issues with accurate snapping and rotation accuracy. Can see when choose Add in Geometry among other scenarios
• Snap to angles like 45 degrees (mid point) when adding node on angled object and in general
• Even though snap shows highlighted with yellow both angles, not always being 100% snapped.
• Should snap to all layers when snap to all layers is set. Doesn't snap all, just some (angles in simple geometry illustration)
• Snap to mid and center when placing object within another angled object like 45 degrees
• When Breaking Curve, stroke alignment goes auto from inside to center. Should maintain stroke alignment after breaking.
• Bush should also be able to snap
• Element multiplied along a line / curve / shape
• Drag and drop color to swop in Color Studio (same as Shift + X)
• Stroke with multiple objects and stroke width are acting strange and not keeping up. Showing one width
• Something strange going on with stroke on Pressure and Properties. When expanding,, the width change (no fill color)
• Don't exit Symbol when clicking on art board or deselecting symbol. Should maintain until exit / escape some sort.
• Pressure for Stroke acts inconsistent, not always adding pressure variations
• CMD + J repeat doesn't work when moving with node tool on entire object. (Needed for further accuracy sometimes)
• Ability to Option Drag for duplicate layer when dragging with Node >Tool
• Ability to snap canvas rotation by holding shift, and making the tools work as if it was in plane mode (example Flip tool)
• See some form of angle value when rotating canvas and with ability to reset rotation easily
• Snap to midpoint between two nodes when adding node in an angled object
• Ability to subtract multiple times from same object with Geometry non destructive
• Elements not being 100% aligned in rotation even when rotational point according to snap should be 100% centered.
• Some simple gaussian blur and outer glow on a simple illustration with around 50 vector lines makes Macbook Pro overheat a lot
• Rotation of two centered elements does not rotate 100% around center when rotating manually (See when zooomed in)
• Ability to make dots with brush tool, now you have to drag a little for marking.

Keep up the good work. Feel free to contact me if anything!