Taelor

Hi v_kyr, Thanks for your suggestion! I did not know there would be a difference, so will be more aware of the file types that I use in AD in the future. Cheers :-)

Hi all, I am still seeking help in learning the steps to take when I need to do a 45' cut (miter) on an imported image. Any and all suggestions welcomed, as well as any suggestions on cutting in general. Also, I am surprised that here is no knife tool like I used in DrawPlus X5-8. Any one know when it will be added? Super confused as to why there was not one included from the beginning... Thanks for your assistance :-)

Hi firstdefence, what I was really hoping for was an explanation on how to do a miter cut, even if it did not work with this particular design. Thank you thought, for your suggestion re: some other object in the corner as opposed to mitering. I may use that idea on another project :-) JimmyJack, your design is what I was hoping to do. (I realize my red triangles were not perfect, but only there to assist with providing clarity for what I was hoping to achieve). The thing is, as I stated in my first posting, I am very new, and was hoping for clear, direct instructions on how to do the miter cut, which I was also hoping would allow me to transfer that knowledge to other types of cuts. The only tool that I found to remove material was the Selection Brush Tool in Pixel Persona, but that tool does not allow for the creation of clean lines. Would you mind very much providing step-by-step instructions on how you achieved the miter cut? I really appreciate you taking the time to assist me!! Cheers!

Hi, Please help! I am trying to create a border using a jpg image I imported into Affinity Designer . I need to cut the image at a 45' angle (miter) so that it joins nicely at each corner. I have spent at least 1.5 hours trying to figure things out on my own, then the past two hours on-line trying to find solutions to my problem, but nothing has worked. For clarity, I have covered each area of the image I want removed in red, in the image I attached. I am very NEW to this program, and graphic design in general, so would appreciate any help with instructions that are very clear :-) Thanks for your assistance! KitchenTool Border.afdesign

I was having the same issue with the Selection Brush i.e.: it was set to Add instead of Subtract. This leads me to believe that I am not the only person that may be frustrated with the lack of clarity on which setting is active, A or S; it really isn't that obvious. A suggestion would be for the developers to have the tabs become brighter (or a different colour, or flash, or....) in order to clearly indicate which state the tool is in. Cheers!