frnq

Hi, Thank You and great work! Soft is awesome! I would like to ask about clip to canvas - with multiple artboards it is always clipping (can't switch this off) - it makes problem if i would like export to pdf with bleed. Normaly i would setup for example 3mm bleed in document setup - create for example 2 artboards - for poster and for leaflet. Then if i would like export pdf for each artboard i can't do this with bleed (artworks are always clipped to artboards). Workaround is create temporary new dokument with one artboard, copy / paste - and then export - when in document is one artboard clipping work properly (i can switch this on/off) and bleed is exporting properly in pdf.

Hi, Windows 7x64 - i have the same issue - "use fill" - in fact it is remembered but only for first node - when i put second node "use fill" is getting unchecked. It would be also less confusing if "use fill" would synchronise with color panel - when i draw curve with pen tool or pencil tool and pick some color from color wheel - curve is filling out with selected color - but "use fill" checkbox remain unchecked.

Hi, Windows 7 64bit, Wacom Bamboo CTL-470/K - also pressure not working. Another strange thing - velocity controler works with mouse (however, it detects very fine thickness with the very intensive mouse movement - is far too little sensitive), and do not work at all with wacom pen.

Hey guys - i'm on Windows 7 64bit. I have problem with "sychronise defaults to current selection" with "pen tool". it's looks like "use fill" do not synchronise - and fill color is reverting to previous state just after placing first node. Steps looks like this: 1) create curve with pen tool set use fill and set fill color to blue 2) push synchronise defaults to current selection 3) escape 4) select pen tool > fill color is blue - that is good, use fill is unchecked - it should be checked as previous curve (step 1) 5) when placeing first node of curve fill color is automaticaly changing state to none. Thank You