Jump to content


  • Content count

  • Joined

  • Last visited

  1. How do I select an image (not the whole document or canvas) and move it up and down to center it in the canvas? using selection brush tool? I know it sounds simple but I couldn't figure out how to do it on Affinity. Thank you!
  2. Update: I have used carl123 template and it's making it easier. I use two horizontal lines as a guideline for all the faces (I don't know if that's what you meant carl123 by guidelines for chin and eyes, is it the red and green line that appears when you center the face??) Then I place the others so that they could match the first example. I was wondering if there is a way to measure the circumference of the face itself so that all the others can look the same size? Also, although the horizontal guidelines help tremendously, when I click on each image, the pixel size appear to be different (when I look to the top left it says 3000x2000 pixels @88dpi for one and 600x600 pixels @ 19x19dpi for another) Shouldn't they all say the same pixel size??? Thank you for any help!
  3. Thank you! I have been following your guidelines and it looks like I'm doing it right now! But all the images are on top of each other so when I try to export each one separately, it always saves as the same image. How do I make them separate image/layer as I continue to work on them?
  4. No, they will be saved under separate names. They are all pictures that will be shown in a slideshow presentation basically.
  5. Hi, I am working on a project that requires several photos (at least 80 of them) to have the same size and pixel count. The photos are faces of men and women from different races and background. I have set the Canvas and Document size to be the same, cropped them with the same width and length, and saved each of them under the same Pixel Size. However, because faces are different in sizes and shapes; some are larger and some are thinner or smaller, the results still vary tremendously. I would like to find out any way possible to measure or set the pixel sizes to be the same for ALL faces please. I have attached what I'm hoping to be an example of the faces just to give an idea. Again, shapes and sizes vary normal but I wanted to have a similar pixel size so that the area to be studied is still the same size if that makes sense. Thank you for your help!