Jump to content

studiotomi

Members
  • Content Count

    2
  • Joined

  • Last visited

  1. There are two instances in particular where I need to be able to do this. First, I have a set of objects, that are in a line, that I need to rotate to an arbitrary/unknown angle. In the graphic below, I need to get the circles rotated around the bottom right corner such that their center point is on the dashed red line. Second, I layout designs to be cut on a laser cutter, so often I need to know the length of an arbitrary line(usually the diagonal of a rectangle), so that I can craft other parts to match them. To measure them, I rotate it to either 0 or 90 and take a look at the object properties. Yes I could use good ole pythagoras' theorem, but I'd rather not have to pop out of the program, if possible
  2. Is it possible to snap to points or objects when rotating an object?
×
×
  • Create New...

Important Information

Please note the Annual Company Closure section in the Terms of Use. These are the Terms of Use you will be asked to agree to if you join the forum. | Privacy Policy | Guidelines | We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.