I just updated to version 1.10.4.1198 (the most recent). Before that I was running version 1.10.1. Since the update, I have had a very peculiar printer margin bug, where the software incorrectly applies the printer margins of my printer, but only if I click the 'printer properties' button next to printer selection. This happens to old documents (made in the 1.10.1 version) and new documents, made in the 1.10.4 version. It is fully predictable and reproducible for me.
Some general info.
OS: Windows 10 (fully updated)
Hardware acceleration is ON
No unusual or different hardware installed or connected since update
Printer: HP ENVY Photo 6234 with most recent firmware
When I open the print dialogue window, the correct printer margins are grabbed and shown in a red, dotted line. See image.
Upon clicking the properties button, followed by 'ok', the margins change. No matter what I change in properties. Even if I change nothing in the properties. Just clicking the button followed by 'ok' changes the margins to this (see below). This does not happen when I click 'cancel' in the properties window.
If I print this, I indeed miss a 16mm margin on the top as well as the (correct) original 16mm margin on the right hand side, which this red dotted line does not show. The latter makes sense, because my printer simply cannot print in that 16mm area on the right.
I can work around it, funnily enough. If I change the orientation to portrait, I get this:
I then force the bug again by clicking 'properties' and 'ok' and I get this:
And then turn it back to landscape and voila... back to where I started, only with my printer properties altered.
Not quite the user experience as it should be, though
A final point: if I go into spread setup and set the margins of the spread by clicking 'Retrieve Margins from Printer', it does grab the correct margins to use on the page. I have only experienced this problem exactly as described above, and no-where else.
