Lindee

@DWright - thank you so much! That did it! Lindee

This is the one that started out fine and then changed. It was exported from iPad as EPS. snowman1.eps

Which EPS? For AI, I'm using CC and it's up-to=date. For Affinity Designer, it's new as of Christmas.

Thanks. @DWright These are all still outlined. I can't see it on iPad. The lines don't look any different. I can't see it until I view it in either Illustrator (turn off Preview) or my embroidery software. Last night I redrew 3 pieces. One was fine and 2 were outlined again. To me, I was using the same tools (Pen) in the same way so I really don't know how it happens. And they don't look any different on the iPad so there's no way to tell until after I've done all that work. Even if I set the pen width to .2mm, I have outlined strokes. It's making me crazy!

@DWright did you figure out what I'm doing? Because it's happening again. I can't see it until I get it back on my Mac and then I've done a TON of work without realizing I have a problem.

Thanks! Sending now. I've mostly redrawn them all but I'm so paranoid that I do an export after each one to make sure it's OK since I don't know what I did that caused it.

I'm a new user. I've been tracing bitmap images to use in my embroidery software. Something happened in a recent file and I don't know what. In the attached image, you can see the upper half has single lines but the bottom half as outlined the strokes. I used the pen tool for the entire design. It all looks the same to me in Designer on iPad but when I bring into my embroidery software, I see this (it only shows wireframes). I need to have a single line version to work properly in my embroidery app. I have pressure sensitivity turned off and an even width stroke selected. I've set my layers to "vector." I tried copying the design to a new file, deleting the bad parts and retracing but I get the same result. I just can't see it until I export as eps and import into Punto. If I start fresh in a new document, the outlines are correct. What am I doing that's causing this? Is there a way to see when it starts happening in Designer before I get too far? Is there a way to change these back to "normal" single strokes or do I need to redraw everything?