Jump to content

Stv

New Members
  • Content Count

    1
  • Joined

  • Last visited

  1. I’m working a document where I set the units to inches, and need to represent typical fractional lumber measurements: x.125, x.25, x.375, etc.. The transform panel rounds everything to a single decimal place. So entering an item to have a width of .125 (1/8th inch), displays as .1. Adding .125 it displays as .2. Repeating two more times adding .125 to the item should end up as .5, but Affinity Designer shows it to be .4. (Internally AD appears to be storing the result rounded to 1 decimal place) Is there not an option to control the precision/decimal places? As an alternative I thought
×
×
  • Create New...

Important Information

Please note there is currently a delay in replying to some post. See pinned thread in the Questions forum. These are the Terms of Use you will be asked to agree to if you join the forum. | Privacy Policy | Guidelines | We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.