I’ve run into a rather odd problem that I can’t seem to sort out. I was trying to make a flower pattern with overlapping petals by duplicating an object, rotating it, and then using the power duplicate to generate the remainder of the petals. I have presented a simplified example below. The problem is that the final petal (B in the example) is not properly ordered, i.e. I want petal B to be above A but below C to properly complete the pattern. I’ve tried putting B down one level, but then A is wrong. I’ve also tried moving layers in the layer stack, but to no avail. I suspect the problem may be that because it is circular, I have come back to the starting point (petal C) which is at the top of the layer stack while petal B is at the bottom of the layer stack.