Companion Posted October 14, 2019 Share Posted October 14, 2019 I discovered this while trying to align individual nodes on multiple paths today. The simplest case to reproduce is as follows: Draw 3 overlapping paths with three 'sharp' nodes each: Start, (approx) middle and end. Using the Node tool, select the middle nodes of each path Choose Align Horizontally: Center and Align Vertically: Center Observe the center points. Depending on the starting positions of the nodes, they may now be curved instead of sharp, and oddly curved when viewed up close. In this case, I would expect the nodes to stay the same type (sharp to stay sharp, curved to stay curved). The strange curved behaviour seen in panel 3 attached seems especially wrong though, and currently means I can't use the align tool for this job. Let me know if I can provide any more info. Thanks! Quote Link to comment Share on other sites More sharing options...
Staff MEB Posted October 15, 2019 Staff Share Posted October 15, 2019 Hi Companion, Thanks for reporting this. Issue logged to be looked at. They will be aligned correctly if you perform the centre aligns in two separate steps. Quote A Guide to Learning Affinity Software Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.