How to Visualise / Edit a Mask Modified with Adjustment Layers

[Gibney 0]

Hi, I’m Relatively new to Affinity Photo (both on iPad & Mac), and have the same problem on both platforms.  I hope i’m posting this question in the right place.

I’m trying to make a mask that targets the sky in the attached image (including the small areas in the roof parapet and the gaps in the trees). I have:

1. Created a luminosity mask (see image 2), that I now want to adjust from being grey scale (see image 3) to pure black & white
2. l’ve created two child layers to the mask (curves and levels) and set them both to target the Alpha channels - see image 4 (I know I can paint on these masks to further target the areas they are applied to)

The problem that I have is that I can’t find a way to visualise purely the mask when I’m adjusting the curves / levels layer. When I put the mask layer into ‘Solo’ mode - I can only see the original luminosity mask, and can’t see the impact of any changes to the mask that are caused by the curves / levels adjustments.

Is there a way to do this, or am I missing something?  Is there a problem with the workflow I’m using?

Any advise, hints, tips or pointers will be much appreciated.

Thanks..... Bernie

 

Edited September 18 by Gibney
Fixed a few typos

[DWright 220]

Is it possible for you to send me a copy of your .afphoto file for me to test

[Gibney 0]

1 hour ago, DWright said:

Is it possible for you to send me a copy of your .afphoto file for me to test

Sure - via email / Dropbox? If so - what ID?

[DWright 220]

Please use the following Dropbox upload link to send me the file

https://www.dropbox.com/request/mKMaIkLqZSOGMPomzWIk

 

[Gibney 0]

28 minutes ago, DWright said:

Please use the following Dropbox upload link to send me the file

https://www.dropbox.com/request/mKMaIkLqZSOGMPomzWIk

 

Done