ChrisP Posted May 15, 2015 Share Posted May 15, 2015 Hi, I placed my points for my shape and then adjusted the curves with the node tool. After that I highlighted the curved nodes that were broken and I clicked "smooth" button to rejoin the handles. I then wanted to adjust some to pure horizontal. Typically in the past, I just held the SHIFT ket and it snaps to the horizontal plane (or the vertical if I needed it to). When I try to do this it snaps to some obscure angle and I can't get it to snap to either 0 or 90 degrees. Any ideas? Bug? Thanks Quote Link to comment Share on other sites More sharing options...
Staff MEB Posted May 15, 2015 Staff Share Posted May 15, 2015 I believe only the Pen tool snaps to steps of 45º. The Node tool (control handles) never snapped to the horizontal or vertical plane. Pressing shift while in the Node Tool only constrains the control handles movement to the direction defined by themselves, that is, you can only extend them without changing their angle. So if you change their angle while dragging and then press shift, they will return to the original angle they were before you start dragging them. Quote A Guide to Learning Affinity Software Link to comment Share on other sites More sharing options...
ChrisP Posted May 15, 2015 Author Share Posted May 15, 2015 MEB, Can you put this down as requested feature? I depend on this feature in AI and it is a little frustrating not being able to do it in AD. If others have a workaround I would love to hear it. Thanks as always, Chris Quote Link to comment Share on other sites More sharing options...
Staff MEB Posted May 15, 2015 Staff Share Posted May 15, 2015 Moved to Feature Requests section. Quote A Guide to Learning Affinity Software Link to comment Share on other sites More sharing options...
ChrisP Posted May 15, 2015 Author Share Posted May 15, 2015 Your the Man!!! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.