HYR Posted May 3, 2019 Share Posted May 3, 2019 I'm finding that often times whenever I go to export an artboard slice is off by 1px. Moving the slice by 1px allows me to export (sometimes, not always because I can't get it to line up exactly) but the change doesn't stick. So i'll have to go back to the vector persona and select the artboard and do "0px - 1" in the X to get it to line up correctly. This occurs on whole pixel artboards, meaning the X/Y and H/W values are all whole pixel values. Am I the only one? Link to comment Share on other sites More sharing options...
Staff Sean P Posted May 7, 2019 Staff Share Posted May 7, 2019 Hi HYR, This is a known issue that is already with development and has been discussed in the thread below. Essentially if the start position of the Artboard is on a half pixel it will add the extra pixel. However it is no longer possible to see whether it is on that half pixel, so not easily correctable as it was in 1.6. Link to comment Share on other sites More sharing options...
HYR Posted May 7, 2019 Author Share Posted May 7, 2019 @Sean P Thanks for the heads up. Link to comment Share on other sites More sharing options...
lepr Posted May 7, 2019 Share Posted May 7, 2019 . Link to comment Share on other sites More sharing options...
Recommended Posts