WalterBeiter Posted April 21, 2015 Share Posted April 21, 2015 I created a document which is now ready for printing. I realized, that I made it to big. A few millimeters. So I created a slice in the export personna and some guide lines, to cut off 2 millimeters on each side. Now, slices do not snap to my guide lines, and I just cannot position it properly. If there is an other way to cut my document by 2 millimeters on each side, let me know. I just need to export it as pdf for printing. Quote Link to comment Share on other sites More sharing options...
Staff MEB Posted April 21, 2015 Staff Share Posted April 21, 2015 Hello WalterBeiter, - change the document size by removing 4mm from the width field in the Document Setup dialog; - make sure that Anchor to Page is enabled, and set the Anchor to the middle of the square. Click OK. This should remove 2mm from each side without affecting object's positions in relation to the page. WalterBeiter 1 Quote A Guide to Learning Affinity Software Link to comment Share on other sites More sharing options...
WalterBeiter Posted April 21, 2015 Author Share Posted April 21, 2015 Hello WalterBeiter, - change the document size by removing 4mm from the width field in the Document Setup dialog; - make sure that Anchor to Page is enabled, and set the Anchor to the middle of the square. Click OK. This should remove 2mm from each side without affecting object's positions in relation to the page. Thank you so much. this helped a lot. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.