Exporting PDF Issue or just me?

[jswingchun 0]

I created a document with a .125 bleed. When I export it the two objects in the upper right corner do not go out to the bleed. I exported as PDF, EPS and JPEG (I haven't tried other formats) and all acted the same way. If I rotate all of the objects and export, the problem follows those two objects, in other words, the bottom left two objects do not reach out to the bleed. Is there some setting I am missing?

Attached is a screen shot of how it looks in Publisher and how the exported file looks.

[jswingchun 0]

I'm bumping this, hoping for a reply of some sort.

[walt.farrell 895]

Welcome the the Serif Affinity forum.

It would help if we could have the .afpub file to look at.

[jswingchun 0]

Here is the file, thanks for the response.

k6DigipakPublisher.afpub

[jswingchun 0]

FORGET IT! I was being stupid. I was confusing the margin guides with the bleed and was working in preview mode so I didn't see that those pieces were out to the document edge, not to the bleed edge.

Ooops.

[MikeW 1,366]

23 minutes ago, jswingchun said:

FORGET IT! I was being stupid. I was confusing the margin guides with the bleed and was working in preview mode so I didn't see that those pieces were out to the document edge, not to the bleed edge.

Ooops.

Glad we could help!

I was downloading it and got a phone call, had to followup with uploads, etc...then I forgot to come back to it. So I'm glad that you discovered the issue.

Mike