Jump to content

1.7 Beta freezes my Mac

Recommended Posts

Today, I froze my Mac again.  I was doing a lot more cloning that a reasonable person would normally be performing.  After I had been extensively cutting power lines out of complex tree limbs, I moved over to perform a pen selection and move (after the moves, I was using the clone brush to blend the seams).  After the second select and move, while I was doing the seam blend, I got the beach ball which continued to spin for about 1 minute, and after the spinning ball stopped the Mac was frozen.  Fortunately, I had been pressing CMD + S to save as I went along, so recovery was not too bad.  After I shut down (white button),  I was able to complete the remaining cloning operations without any problem until I completed the desired changes.

Share this post

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Create New...

Important Information

Please note there is currently a delay in replying to some post. See pinned thread in the Questions forum. These are the Terms of Use you will be asked to agree to if you join the forum. | Privacy Policy | Guidelines | We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.