pualv Posted September 21, 2018 Posted September 21, 2018 Set up a grid so that it has a gutter (screen is filled with separate squares rather than a grid). Snap only works on top side of each square or right edge of each square. Does not snap to bottom or left edge of each square as expected. Old Bruce 1
Staff MEB Posted October 4, 2018 Staff Posted October 4, 2018 Hi pualv, Welcome to Affinity Forums Sorry the delay getting back to you. We have been a little busy since Publisher's Beta release trying to address all reports. Thanks for lettings us know about this issue. I've logged it to be looked at. A Guide to Learning Affinity Software
Old Bruce Posted October 4, 2018 Posted October 4, 2018 I am not seeing this, it is fiddly but works as it should. I can snap to any edge and or corner from any direction, fiddly yes but it does work for me. Are any of the squares grouped? Mine aren't. Mac Pro (Late 2013) Mac OS 12.7.6 Affinity Designer 2.6.0 | Affinity Photo 2.6.0 | Affinity Publisher 2.6.0 | Beta versions as they appear. I have never mastered color management, period, so I cannot help with that.
Staff MEB Posted October 4, 2018 Staff Posted October 4, 2018 @Old Bruce The squares the OP is referring to are not real square shapes but a grid that uses gutters (in both directions) and thus look like independent squares instead of a regular grid. Old Bruce 1 A Guide to Learning Affinity Software
Old Bruce Posted October 4, 2018 Posted October 4, 2018 Okay I misread and misunderstood. I poked about and my results were the same as the original post. However if I put in at least 4 subdivisions then all was good. Mac Pro (Late 2013) Mac OS 12.7.6 Affinity Designer 2.6.0 | Affinity Photo 2.6.0 | Affinity Publisher 2.6.0 | Beta versions as they appear. I have never mastered color management, period, so I cannot help with that.
Recommended Posts