Masterpage margins error

[Bad_Wolf]

When  setting page margins on a Masterpage, then add that Masterpage to a normal page, the margins of the normal page before adding the masterpage to it are still visible.

These where the steps I have taken :

1. Create new Masterpage
2. In "Spread Setup..." change the margins to : L 15 / T 10 / R 10 / B 25
3. Show ruler
4. Place page guides over the margins
5. Right click on the present page
6. Choose "Apply master"
7. In dialog select To : "All pages" and select "Replace existing"
8. Click "OK".

Now you can see clearly that the print margins coming from the Masterpage are not taken over by the page the Masterpage is applied to. When adding a new page and select the Masterpage inside the dialog, also the print margings of the masterpage are not respected.

I did a small other test not related to this subject, I changed the left margin of a particular page and it was only changed by that page.

Thank you again for bringing Affinity Designer to us. I spend already a lot of time with it, and I like very much what I see. Keep up the great work!

Chris

 

[Chris_K]

Hi Chris 

We are aware of this issue, it has something that has been reported a number of times now. Thank yo for raising this