Jump to content
DNH

Add new Page or Master problem

Recommended Posts

I create a new document with one A4 page and place a design on it. Save the document and it prints OK.

When I open that documet, the design is still on the one page i have created, bu as soon as i add another page or a master the design on the original page has disapeared and in not on any other page. Also all the layer information has gone.

I chosen the option of no spreading.

Disclabels.afpub

Share this post


Link to post
Share on other sites

Found out an anwser, I should of doubled clicked on the page instead of single click. Single click would have been nicer.

Share this post


Link to post
Share on other sites

thanks for your reply. I should experimented a bit more.

One thing I need to know is can you revert to single pages after you have set up as spread format.

Share this post


Link to post
Share on other sites

I've been playing around with the document setup and I think what you need is:

Click on Document Setup tab above Pages (or Click on File in menu bar then Select Document Setup (Ctrl+Shift+P))

In pop-up select Layout tab (about half way down box)

You can toggle Facing Pages on and off here.

Hope that is what you were looking for.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×