Strokes get converted to curves AD-> PDF

[sarituulia]

I'm exporting AD document to PDF. I need to be able to preserve the strokes editable- however, when opened in Illustrator, the strokes have been converted to fills? See attached screenshots The same problen when exporting to SVG- the strokes get converted.

EDIT: I found solution to this in case someone else runs into this problem: when the stroke is set to other than 'Center', it will fill the stroke when exporting.

AD File:PDF in AI

 

[sarituulia]

Solution found.

[Alfred]

Was it the stroke alignment that was causing the problem? 

[firstdefence]

2 hours ago, Skin85 said:

EDIT: I found solution to this in case someone else runs into this problem: when the stroke is set to other than 'Center', it will fill the stroke when exporting.

So centre lined it see's it as a stroke, inner or outer it interprets it as a fill.

[Alfred]

Ta muchly, Dex. I didn’t see the OP’s edit to the ... er ... OP. 

[firstdefence]

Ive tried every PDF export including Advanced features checked and all interpret an inner and outer stroke as a fill, so it effectively expands the stroke.

[Gabe]

Hi all,

This is a known issue and has already been logged with the devs. 

Thanks,

Gabe. 

[sarituulia]

7 hours ago, firstdefence said:

So centre lined it see's it as a stroke, inner or outer it interprets it as a fill.

Exactly. Only took a couple of hours to figure out