nickhell Posted October 31, 2017 Share Posted October 31, 2017 Hi, I have a problem. I have a logo and some parts of it are made of strokes. I want to expand them to curves but when I use the expand stroke command the curves on the stroke become not smooth. Any solutions? The logo it´s like a flower and don't want to manual touch every point or use the pen tool to trace every stroke. I have tried the convert smooth button but I what I get is not good too. I´m using The RC1 Thanks After the smooth curves button: This is the logo part in full view: predick 1 Link to comment Share on other sites More sharing options...
Staff MEB Posted October 31, 2017 Staff Share Posted October 31, 2017 Hi nickhell, Welcome to Affinity Forums This is a known issue when expanding strokes. We hope to improve this later in a future version. Meanwhile if you scale up you logo considerably and perform the expand stroke operation, it should give more accurate results. predick 1 A Guide to Learning Affinity Software Link to comment Share on other sites More sharing options...
nickhell Posted October 31, 2017 Author Share Posted October 31, 2017 Thanks very much. That works better. Link to comment Share on other sites More sharing options...
Recommended Posts