pruus Posted May 30, 2017 Share Posted May 30, 2017 If i place a piechart and and want to change the hole dimension, width (see point 3 on attachement). I can only change radius in degrees (see point 1 in attachment) of the hole, not specify mm. Both is better. The pie has a meassurement in mm ( see point 2 in attachment). Is there a workaround? If no, than please add this function. A_B_C, AHompisp and Alfred 3 Quote Link to comment Share on other sites More sharing options...
A_B_C Posted May 30, 2017 Share Posted May 30, 2017 (I fear the only workaround is doing the math. Since you know the radius of your pie chart as well as the desired radius of the hole in pixels, you can compute the required percent value of the hole radius.) Yes, I would like to see an Absolute Sizes checkbox here as well … :) Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.