Jump to content

Recommended Posts

When using the grid tool with a type "2:1 isometric grid", I noticed the spacing of the grid was different than the one I set in the grid tool. I entered a spacing of 64px so that would make 128px wide but I end up with 114.5 px. Take a look at the screenshot bellow.

post-53523-0-09659800-1488516523_thumb.png

Share this post


Link to post
Share on other sites

Hey eldante,

 

Edited - I think I initially fell into the same trap. The Isometric Grid is measured from the left side of the diamond to the bottom-middle point. I was assuming it was from left to right.

 

For example, on a standard Isometric grid, If you draw a pen line from the left to bottom-middle, rotate it by -30 degrees and then reset the selection box, it should equal your grid spacing. You will need to snap your pen line for it to be accurate in a 2:1 grid. 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×

Important Information

These are the Terms of Use you will be asked to agree to if you join the forum. | Privacy Policy | Guidelines | We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.