Jump to content
Stokestack

[Duplicate] Curve joins are incomplete.

Recommended Posts

I would think it's quite common to make symmetrical shapes by drawing a curve with its ends along a guideline, copying and mirroring it, then aligning the mirror image against the original. I did this, using both a horizontal and vertical guideline to ensure exact alignment. Then I combined the curves.

 

But only one of the two overlapping node pairs was joined to create a continuous curve. The other overlapping nodes were left separate, making a broken curve. In the attached video, I delete the nodes to show that only one pair was joined.

incompleteJoin.mov

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.

×
×
  • Create New...

Important Information

Please note the Annual Company Closure section in the Terms of Use. These are the Terms of Use you will be asked to agree to if you join the forum. | Privacy Policy | Guidelines | We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.