When I “Create Slice”, the Width is increased by 1px.

[reina0617]

When I create a design in Affinity Designer2 and then “Create Slice”, the Slice has a Width increased by 1px.
The version of Affinity Designer2 is 2.5.7.
Is this a bug?
Or is there a way to set it so that it automatically adds 1px when I do “Create Slice”?

[bbrother]

@reina0617

Make sure the width is pixel perfect and that the position of the object you want to  make a slice from and export is pixel perfect. Before investigating values in transform panel do this:

• Go to Preferences → User Interface , and then set the Decimal Places values to 3 or more.
• Then close the Preferences dialog and look at the values in the Transform Panel.

Note: If everything is pixel perfect check to see if any Effects have been applied as they can often add small (or large) ‘extra bits’ to the layers.

Similar questions ↓ have already been asked, so it is always worth searching the forum before asking a question. I hope this helps you solve your problem. Good luck 

[reina0617]

1 hour ago, bbrother said:

@reina0617

Make sure the width is pixel perfect and that the position of the object you want to  make a slice from and export is pixel perfect. Before investigating values in transform panel do this:

• Go to Preferences → User Interface , and then set the Decimal Places values to 3 or more.
• Then close the Preferences dialog and look at the values in the Transform Panel.

Note: If everything is pixel perfect check to see if any Effects have been applied as they can often add small (or large) ‘extra bits’ to the layers.

Similar questions ↓ have already been asked, so it is always worth searching the forum before asking a question. I hope this helps you solve your problem. Good luck 

Thank you for your response.
I also apologize for overlooking the fact that a similar question has been asked in the past, and for asking the question.
I have read through the answers you have given and the questions you have told me about, and it looks like the problem can be solved.
Thank you very much.

[bbrother]

No problem @reina0617, I'm glad I helped. Best regards 😉